Skip to content

EggRider display specificationLink

SizeLink

75mm x 47mm x 35mm

WeightLink

31g

Cable lengthLink

50cm

Handlebar mounting bracketLink

Standard 22.2mm diameter

Clamp screwLink

Hex bolt M3x10mm

Mounting clamp pinLink

2.0mm diameter and around 15mm length

Physical buttonsLink

Power On/Off, Level Up/Down and popular Road/OffRoad mode switch

ConnectorLink

Higo/Julet waterproof 5 pin male/female (see image)

ConnectivityLink

Bluetooth low energy (BLE)

ProtectionLink

Dust and water-resistant - IP65 protection

VoltageLink

Supports direct voltage up to 60V (maximum 52v nominal voltage batteries). We can support systems with higher voltages only with specific controllers and with special connections to 12V output.

Current consumptionLink

  • Full brightness: <= 20 mA
  • Low brightness (dimmed) <= 12 mA

PinoutLink

EggRider V2 display pinout


Last update: February 10, 2023