EggRider V2 display specificationsLink

SizeLink

75mm x 47mm x 35mm

WeightLink

31g

Cable lengthLink

50cm

Handlebar mounting bracketLink

Standard 22.2mm diameter

Clamp screwLink

Hex bolt M3x10mm

Mounting clamp pinLink

2.0mm diameter and around 15mm length

Physical buttonsLink

Power On/Off, Level Up/Down and popular Road/OffRoad mode switch

ConnectorLink

• Higo/Julet waterproof 5 pin male/female (see image)

• KM 5p screw male

ConnectivityLink

Bluetooth low energy (BLE)

ProtectionLink

Dust and water-resistant - IP65 protection

Every EggRider display is designed to comply with a dust and water protection rating IP65 under IEC standard 60529 when each device leaves the factory, but it is not waterproof or dustproof. Water resistance and dust resistance are not permanent conditions and will diminish or be lost over time due to normal wear and tear, device repair, disassembly or damage. The EggRider display is not drop/impact proof and dropping your device may result in loss of water and dust resistance. Damage from drops, impacts and other external forces are not covered under warranty. The EggRider display has been designed to withstand light water jets and should not be used for activities involving water at high velocity.

VoltageLink

Supports direct voltage up to 60V (maximum 52v nominal voltage batteries). We can support systems with higher voltages only with specific controllers and with special connections to 12V output.

Current consumptionLink

• High brightness ~ 17 mA
• Low brightness ~ 9 mA

*values are measured at 12v

PinoutLink